Enumerations
enum	BRepBuilderAPI_FaceError { BRepBuilderAPI_FaceDone, BRepBuilderAPI_NoFace, BRepBuilderAPI_NotPlanar, BRepBuilderAPI_CurveProjectionFailed, BRepBuilderAPI_ParametersOutOfRange }
	Indicates the outcome of the construction of a face, i.e. whether it has been successful or not, as explained below: More...

Enumeration Type Documentation

◆ BRepBuilderAPI_FaceError

Indicates the outcome of the construction of a face, i.e. whether it has been successful or not, as explained below:

BRepBuilderAPI_FaceDone No error occurred. The face is correctly built.
BRepBuilderAPI_NoFace No initialization of the algorithm; only an empty constructor was used.
BRepBuilderAPI_NotPlanar No surface was given and the wire was not planar.
BRepBuilderAPI_CurveProjectionFailed Not used so far.
BRepBuilderAPI_ParametersOutOfRange The parameters given to limit the surface are out of its bounds.

Enumerator
BRepBuilderAPI_FaceDone
BRepBuilderAPI_NoFace
BRepBuilderAPI_NotPlanar
BRepBuilderAPI_CurveProjectionFailed
BRepBuilderAPI_ParametersOutOfRange